Note: All phones must be in idle state to change clock settings. DO NOT PICK UP THE HANDSET.
Elite 48/192/IPK
From the main Attendant Phone (Usually ext 100 or 101)
- Press Feature (FNC) key
- Dial 9 #
- Enter hour and minute via dial pad
- Press recall to change AM/PM settings
- Press Feature (FNC) to save
IPK II
- Press Speaker
- Dial 728
- Dial two digits for the hour (24 hour clock, 13 = 1:00 PM)
- Dial two digits for the minutes (00~59)
- Press Speaker to hang up
NEAX 2000 IVS/IVS2/IPS
- Press TRANSFER, CONF, *
- Press TRANSFER, CONF, #
Display reads [CAT MODE ] - Press REDIAL
Display reads [COMMAND= ] - Press 02, RECALL
Display reads [02> ] - Press 2, RECALL
Display reads [02>2:hh:mm:ss ] (current time) - Enter time in 24 hour, min, sec. format – Example 1:55PM= 135500
- Press CONF to save
Display(reads [OK ]
NOTE: If display reads [DATA ERROR ] the System is password protected. See PASSWORD ENTRY below - Lift handset and hang up.
Password Entry
- Press REDIAL
Display reads [COMMAND= ] - Press 03, RECALL
Display reads [03> ] - Press 7, RECALL
Display reads [03>7: ] - Enter the system password. (If you do not know the password, contact Customer Care)
- Press CONF to save
Display reads [OK ] - Return to step 3 above.
NEAX 2400 RDS/HDS/ICS/IMX/IPX
- Use ATIM command in MAT to set the correct time.